Bluetooth Controller Setup

Dirt Track Gladiators & Full Contact Teams Racing both have limited Bluetooth Controller support. Basic setup steps are below however each controller is slightly different to setup and get running so this is just a general guide in order to get you started. With Android the setup can be different depending on your Android device.


1. Open Settings > Connected devices > Connection preferences > Bluetooth > Pair new device. (Note: On some devices simply disabling Bluetooth then re-enabling it on your device will bring up the same screen and on other devices the Bluetooth setting may be in a different location).

2. Look for a dedicated Bluetooth button on your Controller or check the Controllers manual for the right button combination. Push this button to make your controller visible to your device.

3. Your phone should detect the controller and you can then tap its name to establish the connection. You should now be set to go!



Note: You will need IOS 13 or above to make use of using PS4 & XboxOne controllers, some other Bluetooth controllers may also work.

  1. Begin with your controller turned off. Then to put your controller in pairing mode:
    • With an Xbox Wireless Controller, press the Xbox button to turn on the controller. Then press and hold the Connect button for a few seconds.
    • With a DUALSHOCK®4 Wireless Controller, press and hold the PS and Share buttons at the same time until the light bar begins to flash.
  2. On your device, tap Settings. 
  3. Select Bluetooth and check that it's turned on. 
    • To pair, find the name of your controller under Other Devices. Tap the name to connect. You should now be set to go!
    • To unpair, tap Information  next to the name of the device, then tap Forget This Device.